eng Русский язык

Alcactive Liquid

ALCACTIVE LIQUID is a water solvent based liquid solution formulated to attack and remove vegetable and animal fats and oils from epoxy coatings and from most of the common ferrous alloy metals. Moreover, it can safely be applied on Tin, Zinc and/or Zinc Silicate, Aluminum and galvanized surface coatings and materials.

Characteristics, Advantages & Applications

  • A non-toxic, non-flammable and non-corrosive liquid mixture.
  • Acts as an odor binder and eliminator while giving off a soft scent.
  • Effectively dissolves all fat, vegetable and animal oils, dry or not.
  • Can safely be used on Tin, Zinc, Aluminum and any galvanized or epoxy surface coatings.
  • Can be used as a general purpose cleaner to remove oil and grease deposits.
  • May be applied to any ferrous alloy metals.
  • Ideal to use for “Gas-Free” when sprayed after any hydrocarbon cleaning process as it discharges an additional pleasant lemon aroma.
  • Cost effective, easy to handle and apply.

During 1996, chemical tankers were only permitted to use tank cleaning agents, which had been approved and evaluated by the International Maritime Organisation (IMO). ALCACTIVE LIQUID was evaluated through IMO’s Working Group on the evaluation of Safety and Pollution Hazards of Chemicals (ESPH Working Group) and found to meet the requirements of paragraph 1.8.2 of the P&A Standards.

Physical Properties

ALCACTIVE LIQUID is a water based solvent liquid solution, containing specific salts, detergents, wetting agents and corrosion inhibitors.

Appearance / Color White liquid
Odor Soft
Specific gravity 1.02/15°C
pH 8
Order No Size (in litres) Container
833004 30 Plastic jerrican

Application and Use

A. Dosing Procedure

Rock and Roll method: Add 15-20 litres of ALCACTIVE LIQUID for every ton of water at the point where the tank is filled to 30% of its capacity.

Circulation method: A solution of 5-10% must be prepared by diluting ALCACTIVE LIQUID with water.

Injection method: Prepare a solution of 3-6% by diluting ALCACTIVE LIQUID with water.

B. Cleaning Procedure

Rock and Roll method: After you have filled the tank with water (fresh or seawater) to 30% of its capacity and added the required amount of ALCACTIVE LIQUID, let it stand for approximately 24 hours. Then fill tank with more water, up to 90% of its capacity level. This way the tank will be cleaned by natural agitation due to wave motion. Leave for a few days, then drain the tank completely and rinse off by ballasting-deballasting the tank 2-3 times with water.

Circulation method: After the solution is prepared, apply by circulating for approximately 6-8 hours. Thereon, wash thoroughly with water.

Injection method: When the prescribed solution is prepared, inject directly to the contaminated area. Afterwards, rinse thoroughly with water.

Safety and Handling

HANDLING Handle with care. Store in a dry, cool and well ventilated environment.
SAFETY IMMEDIATE ACTIONS
Eye Contact Avoid Eye contact. Otherwise, flush with plenty of water for a few minutes. Seek medical attention.
Skin Contact Avoid Skin contact. Otherwise, wash contaminated area thoroughly with water. Seek medical attention.
Inhalation Avoid inhalation of vapors. Otherwise, seek fresh air source at once. Seek medical attention.
If Swallowed Avoid ingestion. Otherwise, consume a considerable quantity of water. Do not induce vomiting. Seek medical attention.
GENERAL INSTRUCTIONS Avoid spillage, splashing and mishandling. Precautionary measures for body protection are strongly recommended before use.

Read the Material Safety Data Sheet before using this product.

For detailed information on safety and health, please refer to Material Safety Data Sheet and/or Product Label.

Яндекс.Метрика