Electroclean B

ELECTROCLEAN B is a special blend of chlorinated and powerful degreasing solvents formulated to remove grease, oil, carbon deposits and other residues from electric parts and equipment without damaging painted or varnished metal surfaces, insulating materials and cables. Compared to ELECTROCLEAN A QUICK DRY it has slower evaporation rate.

Characteristics, Advantages & Applications

Removes completely oil, grease, carbonaceous and various deposits leaving no dry dirt or stains behind.
Non-corrosive and non-conductive.
Can be used with a specific range of products.
Safe to use on painted or varnished metal surfaces.
A controlled evaporation rate gives efficient cleaning results as opposed to slow drying solutions.
No need to be rinse off after it has been applied.
Strong antistatic capabilities result in the repulsion of suspended solids in the air such as dust, fumes and dirt.
Preserves and maintains electrical equipment in its original state.
Cost effective, easy to apply and ready to use.

Physical Properties

ELECTROCLEAN B is a vaporous, volatile, concentrated product of low flammability, non-corrosive and non-conductive with controlled evaporation rate.

Order No	Size (in litres)	Container
Appearance / Color	Clear, colorless liquid
Odor	Ethereal
Specific gravity	1.12/15°C
Flash Point	>100°C
Vapor Density	Heavier than air
832011	25	Steel drum

Application and Use

A. Dosing Procedure

ELECTROCLEAN B must be applied concentrated at a quantity needed to accomplish complete cleaning; this depends on the degree of contamination to the parts/equipment. Therefore, the operator/user is the one to judge the quantity needed depending on the degree of cleaning required in that particular case.

B. Cleaning Procedure

Once the quantity of ELECTROCLEAN B has been determined, apply to contaminated parts/equipment by brushing, wiping or by immersion (for small parts).

All applications must be carried out in areas that are properly ventilated; this is due to the nature of the product.

Note that after use, the product must always be well sealed in its metallic drum.

Safety and Handling

SAFETY	IMMEDIATE ACTIONS
HANDLING	Handle with care. Store in a dry, cool and well ventilated environment.
Eye Contact	Avoid Eye contact. Otherwise, flush with plenty of water for a few minutes. Seek medical attention.
Skin Contact	Avoid Skin contact. Otherwise, wash contaminated area thoroughly with water. Seek medical attention.
Inhalation	Do not breathe gas/vapors. Otherwise, seek fresh air source at once. Seek medical attention. In case of insufficient ventilation, wear suitable respiratory equipment.
If Swallowed	Avoid ingestion. Otherwise, consume a considerable quantity of water. Do not induce vomiting. Seek medical attention.
GENERAL INSTRUCTIONS	Avoid spillage, splashing and mishandling. Precautionary measures for body protection are strongly recommended before use.

Read the Material Safety Data Sheet before using this product.

For detailed information on safety and health, please refer to Material Safety Data Sheet and/or Product Label.