Oil & Grease Remover

OIL AND GREASE REMOVER is an advanced mixture of biodegradable raw materials and a light aromatic solvent. It effectively removes all kinds and types of oil, grease, fat and light carbonaceous deposits from metal, plastic and rubber surfaces and parts. Acts quickly and thoroughly, and it can be effectively combined with a broad range of products. It is also applicable to plastic, rubber, epoxy and zinc compounds, as well as to painted, coated and varnished surfaces.

Characteristics, Advantages & Applications

Consists of water-based raw materials.
Effectively removes all kinds and types of oil, grease, fat and light carbonaceous deposits from metal, plastic and rubber surfaces and parts.
Acts quickly and thoroughly.
Non-corrosive, non-toxic, non-chlorinated product.
Can be used efficiently as cleaning agent for engine rooms, decks, cargo holds and tanks.
Applicable to plastic, rubber, epoxy and zinc compounds as well as to painted coated and varnished surfaces.
Can be combined with a broad range of products.
Readily biodegradable.
Cost effective, easy to apply and use.

Physical Properties

OIL AND GREASE REMOVER is a liquid solution that contains an aromatic solvent, non ionic, surface-active agents and biodegradable, water-based raw materials.

Order No	Size (in litres)	Container
Appearance / Color	Light yellow liquid
Odor	Slight Aromatic
Specific gravity	0.90/20°C
Flash Point	>60°C
Stability	Very Stable
832521	25	Steel drum
832121	210	Steel drum

Application and Use

A. Dosing Procedure

OIL AND GREASE REMOVER may be applied concentrated or diluted with water. The quantity to be used is proportional to the degree of contamination, the available downtime, the surface area to be covered and the desired degree of cleaning. Therefore, the user is the one to consider the necessary quantity. For heavy duty cleaning and degreasing, OIL AND GREASE REMOVER can be used undiluted whereas for lighter contamination can be used diluted with water depending on the degree and nature of the contamination.

B. Cleaning Procedure

Once the quantity has been determined, apply using any of the following methods: brushing and soaking/immersion.

Brushing is applicable to situations with light accumulation, large and small surface areas and highly contaminated parts or engine components.

Soaking/Immersion is used in situations where we deal with dismantled parts, articles and engine components. Here, brushing may be applied in coordination with immersion to remove heavy accumulation.

After the application, no matter which method is used, leave the solution to soak for as long as necessary and rinse with fresh water (in some cases, a high pressure water supply is recommended).

Safety and Handling

SAFETY	IMMEDIATE ACTIONS
HANDLING	Handle with care. Store in a dry, cool and well ventilated environment.
Eye Contact	Avoid Eye contact. Otherwise, flush with plenty of water for a few minutes. Seek medical attention.
Skin Contact	Avoid Skin contact. Otherwise, wash contaminated area thoroughly with water. Seek medical attention.
Inhalation	Avoid inhalation of vapors. Otherwise, seek fresh air source at once. Seek medical attention.
If Swallowed	Avoid ingestion. Otherwise, consume a considerable quantity of water. Do not induce vomiting. Seek medical attention.
GENERAL INSTRUCTIONS	Avoid spillage, splashing and mishandling. Precautionary measures for body protection are strongly recommended before use.

Read the Material Safety Data Sheet before using this product.

For detailed information on safety and health, please refer to Material Safety Data Sheet and/or Product Label.